Data files are enclosed with the TOCHNOG distribution.
These files have several purposes. First, they show the analysis
capabilities of TOCHNOG. Second, these input files enable an easy start in
performing calculations yourself. Third, the data items
**target_item** and **target_value** are used in the data part,
allowing you to test TOCHNOG on your specific computer system.
This manual only contains results with some of the input files
(examp1.dat, examp2.dat, etc..).

- Example 1: Backward facing step (fluid flow)
- Example 2: Confined compression of fluid filled porous material
- Example 3: Plasticity in plate with circular hole
- Example 4: Two-dimensional convection and diffusion
- Example 5: Inverse modeling of indenter test
- Example 6: Impact of metal plate, local mesh refinement
- Example 7: Global mesh refinement over polynomial domain
- Example 8: Residual remeshing near heat spot
- Example 9: 2D Impact of metal plate, rebuilding of mesh after large deformations.
- Example 10: Shear of low-tension material (cracking)
- Example 11: Propagation of a disturbance in the wave equation.
- Example 12: Contact frictional heat generation.
- Example 13: Automatically embedded tendon with local mesh refinement
- Example 14: Continuous metal forming.
- Example 15: Generation of two holes in 2D mesh.
- Example 16: Bearing capacity of foundation.
- Example 17: Hertz contact problem.
- Example 18: Thermally induced stresses in plate.
- Example 19: Nonlocal plasticity in softening bar.
- Example 20: Three dimensional local mesh refinement near heat source.
- Example 22: Constant volume cylindrical compression with Modified Cam Clay.
- Example 23: Automatic local mesh refinement near shear band.
- Example 24: 3D Impact of metal plate, rebuilding of mesh after large deformations.

tochnog 2001-09-02